POMEX GRANITE ADHESIVE
areas of usage
- For bonding coating materials such as granite, ceramic, natural granite, large size ceramic, porcelain ceramic, cotto
- In places with heavy pedestrian and freight traffic such as shopping malls, hospitals, schools and workplaces,
- On balconies, terraces, wet areas
- Ceramic coating on old granite and marble.
- It is used for applications on floors and walls indoors and on the floor outdoors.
features of product
- It provides very strong adhesion.
- It is resistant to water and frost.
- It is resistant to temperature changes.
Care should be taken to ensure that the application surface is solid, dry, supporting, dust-free and clean, as well as level. Any oil, grease, rust and paraffin residue that will reduce adherence should be thoroughly cleaned and there should be no loose parts on the surface. Damaged surfaces with a depth of 5 to 20 mm should be repaired two days in advance with eile TH 60 or eile TH 70 repair mortars. If the application surface or ambient temperature is above +25 °C; The application surface should be wetted and waited until there is no free water left. Highly absorbent surfaces such as gypsum-plasterboard, gypsum plaster and aerated concrete can be primed with eile PRIMER E to eliminate the risk of premature drying of the adhesive product.
The appropriate amount of water is poured into the clean mixing bowl with the help of a scale. POMEX Granite Adhesive Mortar is added slowly. Mix with a low speed mixer for 3 - 5 minutes until a homogeneous mixture is obtained. The material is left to rest for 5 minutes and is ready for use by mixing again for 20-30 seconds.
Karışım Oranı: For 25 kg of powder: 6-7.0 liters of water -- For 1 kg of powder product: 0.240-0.280 liters of water
A 1 mm thick layer of POMEX Granite Adhesive is applied to the application surface with the flat side of the trowel. The material is pulled in one direction with the notched side of the trowel to obtain a uniform thickness. When adhering ceramics or tiles of different thicknesses, it is recommended to apply 1 mm thick mortar under each ceramic or tile in order to cover the imperfections on the application surface. In order to ensure good adhesion, force should be applied to the ceramics or tiles with the help of a rubber hammer to ensure that they come into full contact with the adhesive mortar. The application is completed by leaving the recommended joint gap according to the appropriate ceramic or tile size. Pomex flex joint filler products should be used to fill the left joint gaps. Joint application can be started after 24 hours.
- In the application of POMEX Granite Adhesive, if the ambient and surface temperature is below +5°C or above +35°C, appropriate temperatures should be waited. Additionally, application should not be made in extremely hot, rainy or windy weather.
- A proper moisture level is required to increase the performance of the adhesive mortar.
- Ceramics with high water absorption should be saturated with water before application.
- Water and new materials should never be added to the mixture that has started to dry.
- Eile POMAX 28 product should be used for applications higher than 3 meters on the interior and exterior of buildings.
- The joint application can be started after at least 24 hours.
- Joint gaps wider than 6 mm should be filled with pomex rusik joint joint.
- On very porous surfaces, ceramic application should be started after priming the surface with eile ASTAR E product.
- The application should begin after impermeable and shiny surfaces have been primed with eile TU 05 or eile TU-O6 product.
25 kg craft bag
It should be stored in its unopened original packaging in a cool and dry environment, stacked in maximum 10 layers.
