POMEX FLEX ADHESIVE

Care should be taken to ensure that the application surface is solid, dry, supporting, dust-free and clean, as well as level. Any residue that will reduce adherence should be thoroughly cleaned, and there should be no loose parts on the surface. Damaged surfaces should be repaired two days before with eileTH 60 or eileTH 70 repair mortars. Porous surfaces should be wetted and waited until the water layer disappears, leaving the surface moist.

Pour 6 liters or 7.5 liters of water into the clean mixing bowl using a scale. eile Flex Adhesive Mortar is added slowly. Mix with a low speed mixer for 3-5 minutes until a homogeneous mixture is obtained. After resting for 5 minutes, the material is mixed again for 20-30 seconds and becomes ready for use. Notched trowel to be used; It is determined according to the size of the coating material to be applied and the smoothness of the ground to be applied.

Karışım Oranı: For 25 kg powder: 6-7.5 liters of water -- For 1 kg powder product: 0.240-0.300

Eile Flex Adhesive is applied to the application surface in a thickness of 1 mm with the flat side of the steel trowel. Eile Flex Adhesive is applied in one direction to the area that can be coated in approximately 30 minutes with the toothed part of the trowel in the appropriate thickness. The surface is prepared for ceramic or granite coating. The open time of the mortar on the applied surface is checked at regular intervals. While checking the open waiting time, the applied eile Flex Adhesive Mortar is lightly pressed with the finger. If the adhesive gets on the fingers, the ceramic or granite application continues. Otherwise ; This means that the working time of the adhesive product has expired. In this case, the mortar on the surface should be scraped off and new mortar should be applied in its place. The working time, which is 30 minutes under 23 0C and 50% relative humidity conditions, varies depending on temperature, humidity and application surface. In indoor floor applications; If the size of flooring materials other than ceramics and tiles (granite ceramics, glazed porcelain, etc.) is 500 cm2, and for coatings such as ceramics and tiles is 1100 cm2 or larger, in interior and wall applications: flooring materials other than ceramics and tiles (granite ceramics, glazed porcelain) etc.) size 120 cm2; ceramics, tiles etc. For ceramics of 500 cm2 or larger. In outdoor floor and wall applications; The application should be done on both sides. Pomex Flex Joint Filler products should be used to fill the left joint gaps. Joint application can be started after 24 hours.

• If the ambient and surface temperature of Eile Flex Adhesive is below +5°C or above +35°C, appropriate temperatures should be waited. Application should not be made in extremely hot, rainy or windy weather.
• A proper moisture level is required to increase the performance of the adhesive mortar.
• It is not applied on metal surfaces and industrial areas.
• Ceramics with high water absorption should be saturated with water before application.
• Water and new material should not be added to mortar that has started to dry.
• eile POMAX 28 product should be used for applications on the interior and exterior of buildings at a height of more than 3 m.
• On very porous surfaces, ceramic application should be started after priming the surface with eile ASTAR E product.
• The application should be started after impermeable and shiny surfaces are primed with eile TU 05 or eile TU O6 product.
• The joint application can be started after 24 hours on the wall and after 48 hours on the floor.
• Joint gaps wider than 6 mm should be filled with Pomex Rusik Fuga.
• Direct contact of the bonded ceramic with water should be prevented for at least 24 hours.

25 kg craft bag

It should be stored in its unopened original packaging in a cool and dry environment, stacked in maximum 10 layers.

tds