eile BİTÜ-ÇİM
areas of usage
- All underground and aboveground, horizontal and vertical, indoor and outdoor places.
- Foundation and face walls insulation.
- Far leachate insulation in floors like bathroom, kitchen and toilet.
- Balcony and terrace.
- Protecting the concrete against water and microorganisms incoming from the ground.
- Foundation insulation, underneath the cement based screeds.
- Ceilings of underground parking garage.
- in garden terraces against ground humidity.
- in parterre insulation.
- Far attaching low temperature insulation panels.
features of product
- it is easy to prepare,; applied with brush and trowel.
- it is solvent-free, so eco-friendly.
- it can be applied up to 6 mm at once.
- it is flexible and has crack bridging property.
- it can be applied on vertical and horizontal surfaces.
- it is resistant to dilute acid, alkaline, chloride and sulfate ions.
- it is not affected by microorganisms and aggressive underground water.
The application surface should be solid, bearing, dust-free and clean. Any oil, grease, rust, paint, paraffin and curing compound residue which reduce adherence should be removed. The places with active water leakage should be filled with WATERBüND. The corners and the edges should be chamfered with the product eile TH 70. The application surface should be primed.
Mix eile BİTÜ-ÇİM component B [liquid] in its own bucket. Add component A [powder] to the component B bucket slowly. Mix with a low speed mixer far 3-5 minutes until you get a homogenous mixture. Let the mixture resettle far 5 minutes and mix it again far 30 seconds. it is now ready far application.
Karışım Oranı: Component A: 22 kg Component B: 8 kg
After preparing Components A and B, take 1 kg of mixture apart and mix it with about 3kg of water. Mix with a low speed mixer far 3-4 minutes until you get a homogenous mixture. This material will be used as the primer layer. Apply the primer homogenously on the surface with a brush. ünce the primer layer is dry, apply the eile BİTÜ-ÇİM mixture of components A and B with a trowel.
- It is not applied to surfaces that are frozen, melting or in danger of freezing.
- The applied surface must be protected against rain, frost and extreme wind for 3 days.
- The temperature of the ground and environment where the application will be made should be between +5 °C and +30 °C. If the temperature conditions do not comply with the allowed values, appropriate temperature values should be waited for the application.
- Foreign materials should never be added.
- Surfaces that have not completed their cure should not be exposed to water.
- Since it is not a UV-resistant material, it must be covered with a suitable material after the drying process.
- The prepared mixture should be consumed within 45 minutes.
in a 30 kg bucket: Component A: 22 kg [powder] - Component B: 8 kg [liquid]
it should be stored in its original unopened package between + 5 °C -+30 °C temperature. Protect the product from direct sunlight.
