eile TH 60
areas of usage
- Repair and leveling of horizontal and vertical surface defects of reinforced concrete structural elements
- In obtaining a solid layer in exposed concrete,
- In smoothing concrete surfaces before waterproofing application,
- Levelling of repaired surfaces with Eile TH 70 product.
features of product
- It has high pressure resistance.
- It has thixotropic properties. Therefore, it provides very good operability overhead and vertically.
- It can only be mixed with water and applied with a trowel.
- It is not corrosive.
- It is resistant to the freeze-thaw cycle.
- It provides high adherence to concrete surfaces and reinforcement.
- Resistant to chlorine and sulfate attacks.
Cement-based surfaces to be repaired must be solid, dust-free, supporting and clean. The surface must be cleaned of residues such as oil, grease and rust that will weaken the adherence. Gaps deeper than 2 cm should be filled with eile TH 70 repair mortar. The application surface should be saturated with water, and there should be no free water left in the area during application.
The recommended amount of mixing water is poured into a clean mixing bucket. eile TH 60 is slowly added to the mixing bucket. It is mixed with a low speed mixer for approximately 3-4 minutes until a homogeneous mixture is obtained. The material is left to rest for about 4 minutes, then mixed again for about 30 seconds and it is ready for use.
Karışım Oranı: For 25 kg bag: 4.0-5.0 lt water -- For 1 kg powder product: 0.160-0.200 lt water -- Mixture Density: 1.7-1.8 gr/ cm3
The mixture is ready for use; It is applied with a trowel to a previously saturated surface with a thickness of 1-4 mm. To obtain a smooth surface; After the mortar absorbs its water, water is sprinkled on the surface with the help of a plasterer's brush. The application is completed in the desired style with a steel trowel.
- It should be consumed within 45 minutes at 20 °C.
- The application surface and ambient temperature affect the hydration reaction of the cement. Therefore, the ambient and ground temperature should be within the allowed temperature range.
- Application should not be made on surfaces that are frozen, melting or in danger of rain or frost within 24 hours.
- The applied surface should be protected from sun and wind for 24 hours.
25 kg kraft bag
It should be stored in its unopened original packaging in a cool and dry environment, stacked in maximum 10 layers.
