eile EPX 630
areas of usage
- It is used on interior and exterior walls and floors, with a joint width of 2-10 mm, for coating materials such as natural stone, ceramics, granite ceramics, etc.
features of product
- Can be applied to dry and damp surfaces.
- It is easy to apply.
- It hardens without shrinkage.
- It shows high early strength.
- Can be used where chemical resistance is required.
- Suitable for drinking water contact.
The application surface must be solid, carrier, dust-free and clean. Residues such as oil, grease, paint, rust and paraffin that will reduce adherence should be removed.
Component A is mixed with a low speed mixer [300-400 rpm for 2-3 minutes], then component B is added and the mixing process is continued for approximately 3-4 minutes until a homogeneous paste consistency is obtained.
Karışım Oranı: A/B: 4.65/0.350 [ wt 1 ]
For Ceramic Bonding: The mortar should be applied to the surface and its thickness should be adjusted with a notched steel trowel suitable for the ceramic size and surface smoothness. For good adhesion, force should be applied with the help of a rubber hammer. In Joint Filler Application: It is applied to the joint gaps with a spatula or gun. Eile EPX 630, which gets on the ceramic surfaces while the application is continuing, should be thoroughly cleaned with warm water and sponge before it freezes. It is very difficult to clean after freezing.
- Application should not be done in extremely hot, windy and rainy weather; if the ambient temperature is below +10 ° C or above +30 ° C.
- In applications to be carried out in extremely cold weather, ambient and ground temperature should be provided with the help of heaters.
- Application should be done by expert practitioners.
- In order for the entire material to cure, the ambient and ground temperature must be within the appropriate range.
- After application, all tools should be cleaned with warm water before they dry.
- It should not be applied on surfaces that are frozen, melting or in danger of freezing within 24 hours.
Set: 5 kg tin bucket -- Component A: 4.650 kg -- Component B: 0.350 kg
It should be stored in its unopened original packaging in a cool and dry environment, protected from direct sunlight and frost.
